Battery maintenance
IPI Key – Battery maintenance
Last updated
IPI Key – Battery maintenance
Last updated
IPI Key comes with a pre-installed battery.
In case your Key does not switch on, please, check if you removed the white plastic from the Key's housing.
To recharge the battery you need to plug a Micro-USB connector to the corresponding port located on the side of the fob. Wait until the LED indicator becomes green. IPI Key 4 will be ready for work.
The lifespan of a lithium-ion rechargeable battery like the LIR2032 3.7 V can be influenced by several factors. Here are some key considerations: charge and discharge cycles, temperature, charge Level, overcharging and over-discharging, and quality of the battery.
While many factors can influence lifespan, a typical lithium-ion battery might last for numerous years under normal usage conditions.
If for some reason you need to replace the battery, please follow the next instructions.
The case is made of two halves latched together.
To replace the battery, open the case and lift the gap between the halves with a fingernail or a plastic card. Do not use metal objects. Remove the old battery by pushing it from the inside using a narrow plastic object. Install the new LIR2032 3.7 V battery on the narrow side (minus contact) of the board. IPI Key will start to work.
IPI Key 4 has a battery LIR2032 3.7 V (RECHARGEABLE)
We highly recommend using the IPI Key with the corresponding type of battery.
Opening the case.
Changing the battery.
Notice: if you don’t want to change the battery by yourself, you can contact any electronic service center that replaces watch batteries.
